Installation

 

  1. Unpack the box and verify that the items listed above are all included.
  2. Hand tighten the two antennas to the brass antenna connecters on the back of the device.
  3. Insert an activated SIM card or USB modem for cellular connectivity.
  4. Secure the power cord to the 19V socket.

NOTE: Make sure the locking clip on the power plug is pointed upward.

  1. Insert the included Ethernet cable into WAN Port 1 and to a LAN port on your DSL or Cable modem or gateway (if available).
  2. Wait until the Power, Online, and VPN lights are steady green (not blinking) on the VPN Gateway’s front panel. See page 4 for cellular status indicators.
  3. Your VPN Gateway is now connected to the GBT network and is ready for use. Continue reading if cellular configuration is required.
  4. Using an Ethernet cable, connect your PC / Laptop to LAN Port 1.
  5. Turn the page for network configuration, including primary or failover cellular access.